Rear Seat

03 May 2004 Rear Seat

Getting the rear seat/baggage area door done was not too difficult. I got sent two left sides instead of a left and right, and after that got straightened out, it was just a matter of clecoing and drilling. The fiberglass top part took a bit of work to get trimmed down. I ended up using a ruler to measure where I would cut, and it worked out ok. To cut it, I used a circular cutoff wheel. Kind of overkill, but I didn’t really have anything else I trusted to cut this. I don’t have a lot of experience with fiberglass, and boy, does it make a big mess. Dust everywhere.