More CreativAir LED Position Lights

06 Nov 2004 More CreativAir LED Position Lights

Here are a few photos showing the LED position lights with the clear epoxy on them after soldering. The soldering was not too difficult, even tho I have almost no experience with electrical soldering. I’ve got lots soldering sheet metal with 2 pound soldering irons, but that’s another story.

Here you can see the blobs of epoxy on the red LED.

Here is the green LED.

Here is the other side of the two LEDs. Notice that I have put some epoxy on the wires, and the connection points as well. This should be good to relieve any potential strain. Thank goodness after testing all worked well, because there was no going back – that epoxy is tough!