Panel progress
The panel is in. Smoke test successful. Builder happy.
Some wiring details
The wiring is almost complete, so I wanted to get just a couple of pictures of the details. Below you can see examples of a butt splice with a metal collar crimped to a resistor an
Trig TY-91 and TT-21 harnesses
Created the two harnesses – took about a full day each. Lots of details to take care of. Had to pull the headset jacks because I couldn’t remember how they were wired.
Flat black vinyl wrap on glareshield
3m 1080 flat black vinyl wrap stuck to the glareshield. I had tried to paint it twice with heat resistant radiator paint but it was a bit glossy and not smooth. The film looks grea
4.8 volts bus for GRT EIS probes
The EIS seems to like 4.8 volts going to its probes and i have 5 that need this so I decided to make a little bus to make it cleaner than a bunch of splices. I “forgot”
Stuff I need to wire
This is all that’s left to do! 🙂 Actually a lot is done. Just need to finish the EFIS, radio, transponder, and connect the panel to the aircraft.