Baffle to cowl clearance above oil cooler
The instructions are pretty clear – keep a 3/8″ to 1/2″ clearance between the upper edge of the baffles and the inside surface of the top cowl. I have that everyw
Alternator B lead install with Littelfuse midi inline 80amp fuse
Installed the b-lead to the alternator. I decided to use the Littelfuse midi fuse inline older, with an 80amp fuse. The are much smaller, lighter, and don’t require me t
More work on the cowl
Now that the snorkel is almost done, let’s see if we can finish up the lower cowl cutouts. (These photos are in reverse order.) Cowl bump is glued on and I’ve added a c
Ground point on firewall
Added this ground point on the firewall. A bit of overkill but I think it is pretty clean, and allowed me to use the braided straps and attach them to the engine case. Note
Starter wiring
Installed the giant starter wire. It’s a fat wire from Eric M. Jones’s Perihelion Design http://www.periheliondesign.com/fatwires.htm (Super-2-CCA, AWG#2) so it should