Heater Valve placement

21 Nov 2010 Heater Valve placement

Van’s includes a nice diagram of where things should go on the firewall. The location of the heater valve is shown clearly, but I am trying to determine if I can place it a bit to the right (left looking at the diagram, right when viewed from the cockpit) since I already have a large hole there that was used for my boost control cable.

2004031620072395_1_original

Speaking of the heater valve, I bought a stainless steel valve from Avery Tools (http://www.averytools.com/) – just felt better to have this made out of stainless rather than the standard aluminum.

2004031620072395_1_original

Update: August 2021

During my annual condition inspection, I found that the control arm came off the heater valve – looks like the spot welds were not good enough. Here’s my repair with some stainless steel rivets. Might explain why I felt that the heater was not working so well. 🙂

Repair in place with two stainless steel pulled rivets.
No Comments

Sorry, the comment form is closed at this time.