Mickey's RV8 Site - Throttle Quadrant upgrade

Topics
Home Firewall Forward (5) Maintenance (1) Workshop (4) Empennage (24) Wings (19) Fuselage (85) Wiring and Electrical (32) Engines (85) Instruments (22) Paint (10) Tips and tricks (22) Ramblings (19) Off Topic (3) Flight Testing (14) General News (9)

What's New
STORIES No new stories COMMENTS last 2 days No new comments LINKS last 2 weeks No recent new links

Technorati

Older Stories

Sunday 21-Nov

Andair fuel pump and filter (0)
Throttle Quadrant upgrade (0)

Tuesday 16-Nov

Propeller arrived (0)

Monday 09-Aug

New engine on order (0)

Saturday 21-Jun

Current Status (0)

Thursday 29-May

Eggenfellner Subaru STI for sale (0)

Saturday 28-Jul

Lower rudder tip - part 4 (0)

Sunday 08-Apr

Builder Sites
RV-8 Kevin Horton RV-8 Larry Bowen RV-8 Randy Lervold RV-7A Bernie and Alex RV-7A Dominik Stalder RV-8 Jim Daniels RV-8 Olivier Le Carbonnier Van's Builder Links

Welcome to Mickey's RV8 Site
Thu, Feb 23 2012 @ 05:08 in Switzerland

Throttle Quadrant upgrade

Sun, Nov 21 2010 @ 20:48 in Switzerland
Contributed by: Mick
Views: 1,655

The old Subaru engine only required a throttle and a boost control, and the propeller pitch was controlled with a knob on the control panel. This meant that I could use the CT 82F DELUXE - 2 Lever throttle quadrant.

Now that I am changing to the Lycoming/Hartzell package, I need to upgrade the quadrant to the CT 83F DELUXE - 3 Lever model.

One complaint that I have about the djm mfg quadrants is that the aluminum levers are guided by aluminum - and I don't like metal to metal contact on things that should move. I believe the guides would be better if they were lined with delrin or even made of delrin, or another nice plastic.

To fix this, I decided to line the inside of the guides with UHMW tape - the same stuff you use to allow the flaps to slide against the top skin of the wings.

First need to cut out some pieces of tape like this - 4 inches long, and a bit more than a 1/4" wide.

Now position it, and then use something to make it stick to the inside edges of the throttle guide. Oh yes, before doing this, be sure to clean the inside of the guides with something to ensure that there is no oil or dirt to cause the tape to not stick correctly.

Once stuck on there, just trim it up. I used a wide post-it to protect the guide from getting scratched or marred by the knife.

Once all three slots are done, on both sides, I put the throttle together and felt the smoooooth motion of the levers as they slide across the UHMW tape instead of the anodized aluminum. The tape is very sticky, so I doubt it will be coming off any time soon.

I also needed to make the throttle quadrant cover a bit wider. Some snips, and a bit of filing did the job.

I had to touch up the paint on the cover where I widened the opening. I also had to make that other part you see here to hold the cables. The one that was on there before didn't have the three holes. I did the painting outside, dried with a heat gun, and just brought them in for the photo.

What's Related
More by Mick More from Fuselage

Story Options
Mail Story to a Friend Printable Story Format

Throttle Quadrant upgrade | 0 comments | Create New Account

The following comments are owned by whomever posted them. This site is not responsible for what they say.