Mickey's RV8 Site - Glareshield Edging

Topics
Home Firewall Forward (5) Maintenance (1) Workshop (4) Empennage (24) Wings (19) Fuselage (85) Wiring and Electrical (32) Engines (85) Instruments (22) Paint (10) Tips and tricks (22) Ramblings (19) Off Topic (3) Flight Testing (14) General News (9)

What's New
STORIES No new stories COMMENTS last 2 days No new comments LINKS last 2 weeks No recent new links

Technorati

Older Stories

Sunday 21-Nov

Andair fuel pump and filter (0)
Throttle Quadrant upgrade (0)

Tuesday 16-Nov

Propeller arrived (0)

Monday 09-Aug

New engine on order (0)

Saturday 21-Jun

Current Status (0)

Thursday 29-May

Eggenfellner Subaru STI for sale (0)

Saturday 28-Jul

Lower rudder tip - part 4 (0)

Sunday 08-Apr

Builder Sites
RV-8 Kevin Horton RV-8 Larry Bowen RV-8 Randy Lervold RV-7A Bernie and Alex RV-7A Dominik Stalder RV-8 Jim Daniels RV-8 Olivier Le Carbonnier Van's Builder Links

Welcome to Mickey's RV8 Site
Sun, Feb 05 2012 @ 21:21 in Switzerland

Glareshield Edging

Sat, Feb 04 2006 @ 14:33 in Switzerland
Contributed by: Mick
Views: 1,566

Got this from Kevin Horton, originally posted by RV-6 builder Mark Nielsen:

==============================
For my glareshield, I mounted a piece of 3/8" soft aluminum tubing (same as
fuel line) along the aft edge of the glareshield. I cut a lengthwise slot
in the tubing, pushed it on the aft edge of the glareshield, and held it in
place with fillets of epoxy along the top and bottom. I was pleased with
the results. It gives the glareshield a nice "beaded" edge that looks right
in place next to the tubular frame that supports it (tip-up canopy). The
tube also stiffens the glareshield considerably and eliminates the "sharp"
aft edge.

To cut the slot in the tubing, I used a 3" cutting disk mounted in a drill
press. I drilled a 3/8" hole near the edge of a 2x4 and cut a slot between
the center of the hole and the edge. This was clamped vertically on the
drill press
so the cutting disc protrudes through the slot into the center of the hole.
The tube was pushed through the hole to cut the slot. (I drew a guide line
along the length of the tube so I could cut the slot straight.)

I used Power Poxy (Walmart) for the fillets. It has the consistency of very
soft modeling clay, is easy to use, sets up in about 30 minutes, and sands
easily. The application tool was my finger moistened with rubbing alcohol.

What's Related
More by Mick More from Fuselage

Story Options
Mail Story to a Friend Printable Story Format

Glareshield Edging | 0 comments | Create New Account

The following comments are owned by whomever posted them. This site is not responsible for what they say.