Here I am trying to figure out which way is up.

Marking out where I will cut it based on measurements.

Cut it with the wife's dremel tool. That thing cuts like a momo fofo. The bottom is good, but in order to get the thing on, I had to cut more from the side.

This will need some trimming, I'm sure. I've seen others cut this down all the way flush with the rudder horns. I'll try to leave as much as possible on there.

I went too far on the bottom as you can see here, but the side is very nice. Can't have it all, and get the thing on the rudder. I'll try to fill it in with some fiberglass, once I get the holes for the lights done.

This article is continued here:

http://www.rv8.ch/article.php?story=20050902211803283