Here are the brackets primed, with the trim servo, and ready for installation.
Here is the whole kit installed in the airplane. It's not yet wired up.
Contributed by: Mick
Here are a couple of pictures showing the electric aileron trim installation. This was very straightforward. The only goof up I did on this was to mix up the two templates, and drilled some unnecessary holes on one side of the seat brackets. No big deal, but if I had read the instructions more carefully....
Here are the brackets primed, with the trim servo, and ready for installation.
Here is the whole kit installed in the airplane. It's not yet wired up.
Comments (0)
Mickey's RV8 Site
http://www.rv8.ch/article.php/20040829163514544