Flop tube aeroquip hose on the left, normal AN-6 fitting on the right. Notice the size difference.
Here is the brass end of the flop tube, and the aeroquip hose. The red fittings seem to have a very small inside diameter on the aeroquip.
Contributed by: Mick
I'm working on putting in the flop tube into the right wing. Now I found a little problem. Why is the ID of the aeroquip hose less than 1/4" when it should be 3/8"?
Flop tube aeroquip hose on the left, normal AN-6 fitting on the right. Notice the size difference.
Here is the brass end of the flop tube, and the aeroquip hose. The red fittings seem to have a very small inside diameter on the aeroquip.
Comments (0)
Mickey's RV8 Site
http://www.rv8.ch/article.php/20040625174334102