Contributed by: Mick
A short note from the net about how to rivet the canopy.Date: Wed, 10 Sep 2003 01:05:23 EDT From: shiprv8@aol.com Subject: Re: Canopy keeper rivets I agree with Scott re stress ......I had the same "gap" at the rear.....I slid my bubble forward until it sat flush on the rear bow, retrimmed the edges and the front One thing I found to be critical was to clamp everything from the rear toward the front....this allowed the bubble to "walk" toward the free end where you can do final trimming....you'll be amazed at the difference....working from front to rear just makes the bubble "pile up" at the worst possible place, i.e. the thick rear Ship
Comments (0)
Mickey's RV8 Site
http://www.rv8.ch/article.php/20030911111232754